The Ultimate Firearms Destination for the Gun Lifestyle

Check Your Serial Numbers: Daniel Defense Safety Notification

Daniel Defense has issued a safety notification for some firearms manufactured over a twelve month period. They tell us some faulty disconnectors have been causing inadvertent doubling. Read their release below then visit this page to check your serial number.

Daniel Defense is committed to the highest level of quality and safety. In keeping with that commitment we are issuing a safety notification related to a condition we identified with the Disconnector in the Fire Control Group. This safety notification applies to certain firearms manufactured between April 1, 2016 and March 3, 2017. In a few cases, a double fire condition has occurred with a single pull of the trigger. In the Company’s spirit to always do the right thing, Daniel Defense will correct any and all potential conditions at no cost to the consumer as part of our 100% Satisfaction Guarantee.

Does This Safety Notification Apply to My Firearm?
Daniel Defense firearms containing a single-stage Fire Control Group, manufactured between April 1, 2016 and March 3, 2017, MAY fall within the scope of this Safety Notification.

This is an important Safety Notification and should be followed by all owners of Daniel Defense firearms.

IDENTIFICATION PROCESS
1) Enter your firearm’s serial number in the box below. (The serial number is located on the left side of the lower receiver.)

Daniel_Defense_Recall02

2) If your firearm’s serial number is indicated to be within the scope of this safety notification STOP USING THE FIREARM IMMEDIATELY and follow the Corrective Action Process.

CORRECTIVE ACTION PROCESS
1) REMOVE THE MAGAZINE, CLEAR THE FIREARM and always follow the NRA Gun Safety Rules.
2) CLICK HERE to fill out the Return Merchandise Authorization Form.
3) A Daniel Defense representative will contact you as soon as possible to provide you with shipping instructions, including a pre-paid and pre-addressed UPS shipping label and box.
4) Remove the upper receiver from the lower receiver by removing the front pivot pin and the rear take down pin. Reference the Daniel Defense owner’s manual at Section 3.7, p. 11 for more detailed instructions.
5) Ship the lower receiver to Daniel Defense using the pre-paid and pre-addressed UPS shipping label and box.
6) Daniel Defense will inspect and perform a corrective action in the most expeditious manner.
7) Once the inspection is complete and any necessary corrective action is taken, the lower receiver will be shipped back to you and tracking information will be provided.
Note – For more information regarding this Safety Notification, please see the following video.

Subscribe to the Free
Newsletter